RFQ/BOM 0 登錄 / 註冊

選擇您的位置

用戶形象

The power conversion of LM2576 loses voltage.

Hardware design
8月 04, 2020 by Drake 330

Ask, I use the recommended 5V conversion circuit in the LM2576S-5 power chip manual to power one of my development boards, which require a lot of power (the official adapter is the maximum 5V, 2A). When I was not connected to the load, the power supply circuit stably output 5V, but when I switched on the development board, the voltage instantly dropped to 4.4V, and then returned to 4.5V, the development board could not start normally, so I used two of these circuits, And connect them in parallel, the voltage is adjusted from 5V to 4.4v, and then back to 4.6V, but the development board can be turned on normally, what I want to know is, can't the maximum current stated on the chip reach 3A? Why is there so much pressure drop? It shouldn't be because of insufficient power.

9H[84$@(JBM$D{OPU22HCV5.jpg

所有評論

user image

Malik 發表於 August 4, 2020

First of all, you have to determine whether the power of the front-end circuit is sufficient, that is, the voltage and current at the input of the LM2576. Secondly, check the back-end circuit to see if it is overloaded or short-circuited. Generally, if there is no problem with the front and rear stages, adjust the capacitance and inductance in the middle.

0
user image

Ellis 發表於 August 4, 2020

Two power supplies together means that your development version is okay. Check if your power supply is not enough?

0
user image

Hanna 發表於 August 4, 2020

See if the input power is small, and try increasing C25

0
user image

Phoenix 發表於 August 4, 2020

It is possible that the power of VBAT is not enough, and the feedback line of pin 4 is far away from the inductor.

0

寫一個答案

您需要登錄才能回覆。 登錄 | 註冊