RFQ/BOM 0 登錄 / 註冊

選擇您的位置

用戶形象

The triode controls the solenoid valve circuit and the board is hot. How to solve it?

Hardware design
10月 21, 2020 by Marguerite 1387

I used this circuit to control the solenoid valve before, but I didn't pay attention after I took over. In a recent experiment, it was found that the temperature of the tiP122 tube rose sharply after it was turned on. The solenoid valve is 24v and the built-in resistance is 18 ohms. The measured Vce is only 0.9v and Ic is 1.1A. Why is it so hot? The board has come out, do you see any help?

所有評論

user image

Wilder 發表於 October 21, 2020

122 plus heat dissipation;

0
user image

Jenelle 發表於 October 21, 2020

The solenoid valve uses a mos tube for such a large current. Triode can also be used for small current

0
user image

Brigitte 發表於 October 21, 2020

First of all, good heat dissipation must be added to the three-connector, and secondly, the internal resistance of the three-connector is large, and it can work for a short time. It is recommended to change the field tube (internal resistance of milliohm level) for long-term work.

0
user image

Guinevere 發表於 October 21, 2020

The transistor has to withstand 1w of dissipation (heating)! ! ! Change to MOS or something else unless good heat dissipation can be ensured.

0

寫一個答案

您需要登錄才能回覆。 登錄 | 註冊