RFQ/BOM 0 登錄 / 註冊

選擇您的位置

用戶形象

Why does the amplifier become a hysteresis comparator after adding positive feedback?

Hardware design
9月 15, 2020 by Harry 1910

As shown in the figure, U2’s chip manual says operational amplIFier

This is the meaning of amplifier

But after adding positive feedback, it becomes a hysteresis comparator

Is the amplifier just like this?

所有評論

user image

Jake 發表於 September 15, 2020

Don't be entangled in these superficial concepts. Comparators should be functionally defined and are essentially amplifiers.

0
user image

Evelyn 發表於 September 15, 2020

Comparators and op amps can be regarded as one kind of things, but there are more limits. If the op amp is connected to a comparator, that is not a problem.

0
user image

Lucy 發表於 September 15, 2020

In principle, the principle is similar. Compensation is omitted inside the comparator. Circuits such as analog bias are comparators. The comparator requires speed, and the operational amplifier requires stability. If the requirements are not high, the two can be interchanged. Generally, the comparator is OC output.

0
user image

Hayden 發表於 September 15, 2020

Many times the op amp can be used as a comparator, but pay attention to the differential mode input voltage range. Some op amps have back-to-back clamp diodes inside the non-inverting and inverting terminals. This kind of op amp is likely to consume a lot of current when used as a comparator. .

ADI has an application note that does not recommend using an op amp as a comparator.

0

寫一個答案

您需要登錄才能回覆。 登錄 | 註冊